en th
PRODUCT
OTHER TASKI JONTEC ESD Inquiries about
products
TASKI JONTEC ESD Static dissipative floor emulsion

Static dissipative floor emulsion specially developed to dissipate electric charges over the surface of any type of floor or let to ground on conductive floors. It builds a warm, high gloss protective film which responds to a wide range of maintenance techniques. Ideal solution for areas where you face a static dissipative issue and for ESD approved floors to help ease cleaning and maintain a good appearance.

  • Delivers a warm gloss, protective layer

  • Fortified with AvetranTM to ensure ESD capabilities

  • ESD approved by independent laboratories

  • Slip resistant according to international standards(ASTMD-2047)

  • Benefits

    • Protects your floor investment against traffic abuses and eases cleaning

    • Eliminates risk of electric shocks and therefore of damages of equipments

    • Fulfills basic requirents of IEC 61340-5-1

    • Guarantees safety for your employees, patients and customers

  • Usage instructions

    1. Treat only stripped and thoroughly rinsed and completely dry floors. Sparingly pour the product onto the floor and evenly spread it while still wet with a polish applicator in overlapping lanes of 1 - 1.5 m.

    2. Always apply 3 coats on the floor and always allow a 60 minutes
minimum drying time in between two coats. After the last coat, 
allow minimum 60 minutes before traffic.

    3. To keep static dissipative capability and high gloss, recoat in
 medium to high traffic areas every 3 months and in low traffic 
 areas every 6 months.

  • Dosage:

    Ready to use, no dilution required.

  • Maintenance:

    Always allow a new treatment to cure for 48 hours before doing any type of wet maintenance.



    Remove loose dirt with a dry mop on a daily base.

    To ensure static dissipative capability, maintain with TASKI Jontec Destat.



    Apply TASKI Jontec Destat 3 times a week for moderate to heavy traffic areas. Apply once a week or as needed on light traffic areas. Do not rinse the floor after application.



    In dry environments, apply 3 times a week to keep static dissipative readings low.

Technical data
Appearance Milky, white liquid
pH value (neat): ≈ 8.9
pH value (in use): ≈ 8.9
Relative density (20°C): 1.029 g/cm3

The above data is typical of normal production and should not be taken as a specification.

Available pack sizes

・TASKI Jontec ESD is available in 2x5L.

Contact

We provide the most appropriate products for customers.
Click below for inquiries.